.jpg)
1/2
IN STOCK
POLYMER FLOORS
DensTop PM 605 Trowel
Cement-polyurethane colored mortar for textured coatings with high chemical resistance and mechanical strength
PRICE
PRICE ON REQUEST
Leave a request — we will send a tailored commercial offer within 30 minutes
DensTop PM 605 Trowel is a three-component, water-based, colored cement-polyurethane mortar for seamless, slip-resistant flooring with excellent chemical, abrasion, mechanical impact and thermal shock resistance.
✓Industrial flooring in oil-refining, pharmaceutical, food-processing and other facilities with increased requirements for chemical resistance and mechanical strength.
✓Flooring subjected to thermal shock and cyclic loading during steam cleaning, spills of hot liquids, exposure to high operating temperatures, freezing and similar conditions.
✓Slip-resistant flooring in wet areas, liquid-filling and draining zones, and sloped forklift traffic areas.
✓Industrial flooring requiring very high chemical resistance to detergents, oils, dilute alkali and acid solutions, hydrocarbons and other aggressive compounds.
✓Wider service-temperature range than epoxy coatings: from -40°C to +150°C.
✓Can be steam-cleaned when the layer thickness exceeds 9 mm.
✓High mechanical strength, including compressive strength, abrasion resistance, resistance to impact loading and mechanical cleaning.
✓Excellent chemical resistance, greater than that of epoxy flooring systems.
✓Can be applied to new concrete after 7 days and to slightly damp surfaces (up to 8%).
✓Can be applied at varying thicknesses to meet the finished coating requirements.
✓Forms a seamless coating without cold joints.
✓Rapid setting.
✓Environmentally friendly: non-toxic, solvent-free and non-flammable.
APPEARANCE AND COLORPigmented cement-based mortar
MIXING RATIO A : B1 : B2, PARTS BY WEIGHT25 : 2,4 : 3,1
MIXTURE DENSITY AT 20°C, KG/M³2100±50
COMPRESSIVE STRENGTH, MPA, 28 DAYS≥60,0
TENSILE STRENGTH AT BENDING, MPA, 28 DAYS≥15,0
BOND STRENGTH WITH CONCRETE SUBSTRATE, MPA, 28 DAYS≥2,0
WEAR RESISTANCE AT ABRASION (TABER METHOD), MG110
POT LIFE AT 20°C, MIN10
FULL CURING TIME AT 20°C AND RELATIVE HUMIDITY 50%, H — PEDESTRIAN TRAFFIC24
FULL CURING TIME AT 20°C AND RELATIVE HUMIDITY 50%, H — PASSENGER-CAR TRAFFIC48
FULL CURING TIME AT 20°C AND RELATIVE HUMIDITY 50%, H — HEAVY-EQUIPMENT TRAFFIC120
MINIMUM / MAXIMUM SERVICE TEMPERATURE, °C — FROM 6 TO 9 MM-25 / +70
MINIMUM / MAXIMUM SERVICE TEMPERATURE, °C — FROM 9 TO 12 MM-40 / +120
MINIMUM / MAXIMUM SERVICE TEMPERATURE, °C — FROM 12 TO 15 MM-40 / +130*
MINIMUM / MAXIMUM APPLICATION TEMPERATURE, °C+10 / +25
MAXIMUM RELATIVE HUMIDITY AIR DURING APPLICATION, %90
MINIMUM / MAXIMUM LAYER THICKNESS, MM6 / 15
CONSUMPTION, KG/M² ON 1 MM**2,1
*Briefly to 150 °C
**Consumption depends from substrate characteristics
// RELATED PRODUCTS
